模具外貿葵花寶典（doc 27頁）

模具外貿葵花寶典內容提要：
1、XXX！你現在有空嗎，我可以問你一些問題嗎？
Could I ask you some questions if you are free?/ Are you free now? May I ask you some questions (a
question)?
2、請問此產品的麵是否為外觀麵？表麵做什麼處理？是曬紋/拋光？
Can you tell me whether the surface of this part is a visible/esthetic one? What will we do for its
surface? Texture or Polishing?
3、請問產品這個麵可否加頂針或頂塊？產品允許加扁頂針嗎？
Does this part need an ejector pin or an ejector bar? Can we add an ejector blade?
4、這個產品的柱位我們打算做司筒。（或鑲針）可以嗎？
Can we add ejector sleeves or ejector pins in the boss of this part?
5、產品的這個位置不能出模，我們打算做行位，在此麵上會有分模線，你接受嗎？
There's an undercut at this position and it needs a slider. It will also have a parting line on
this side, is that OK?
6、產品裏麵的這個位置我們打算做斜頂或內行位，有問題嗎？
We will make the lifter and (inner) slider in this position, will that be a problem?
7、你提供的2D產品圖與3D產品圖不一致，請問以哪一個圖麵為準？
The 2D and 3D drawing you provided is not the same, can you tell me which one is correct?
8、你提供的3D產品圖有的地方沒有出模角，有的地方膠位太厚，有的地方膠位太溥，這些產品問題我們可以自
己修改嗎？修改後會給交給你確認。
There is no draft angle in the 3D drawing, some materials are too thick, and some place are too
thin. Can we modify this part by ourselves? We will send the drawing to you for you to check after
we modify it.

..............................